Lectrosonics UT200c Manual do Utilizador

UT200C FREQUENCY-AGILE HAND-HELD TRANSMITTER OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. Rio Rancho, NM www.lectrosonic

ADJUSTING THE TRANSMITTER FREQUENCY If you are experiencing interference from another signal on your frequency, you may want to change the o

Frequency Agile Handheld Transmitter TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the transmitter

SPECIFICATIONS Operating Frequencies: 537.600 to 607.900 MHz 614.100 to 767.900 MHz RF Power Output: 100mW Pilot Tone: 32.765 kHz, ±2 Hz, 5kHz de

Frequency Agile Handheld Transmitter SERVICE AND REPAIR If your system malfunctions, you should attempt to correct or isolate the trouble

LIMITED ONE YEAR WARRANTYThe equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was pur

INTRODUCTION Thank you for selecting the Lectrosonics UT200C hand-held wireless transmitter. The UT combines over 80 years of engineering

Frequency Agile Handheld Transmitter GENERAL TECHNICAL DESCRIPTION The UT200C transmitters are comprised of a number of functional sub-sy

PILOT TONE SQUELCH The 200 system utilizes an ultrasonic tone modulation of the carrier to operate the receiver squelch. Thi

Frequency Agile Handheld Transmitter CONTROLS AND FUNCTIONS EXTERNAL “P” SWITCH – POWER ON/OFF Audio Power A slide switch

Internal Controls - VariMic Version Caution - Due to the high RF levels surrounding the transmitter, the sound of the Vari

Frequency Agile Handheld Transmitter attenuation or the highest signal level. “0” is maximum attenuation or the lowest signal level. For the maximum

BATTERY INSTALLATION The transmitter is powered by a standard alkaline 9 Volt battery. It is important that you use ONLY ALKALINE or L

Frequency Agile Handheld Transmitter OPERATING INSTRUCTIONS 1) Install a fresh battery according to the instructions on pag